Daewoo IC Forklifts Portland

Inspect a Forklift

There are more than 10,000 workplace injuries connected to forklifts occur every year, according to OSHA and HRSDC reports. A lot of these accidents are caused by operator error. Lack of appropriate equipment maintenance and check causes numerous others. Forklift operation and maintenance is not just the reason for personal injuries, but also of property damage. Forklifts could damage building structures, overhead pipes and sprinklers, and other equipment when operated wrongly. The following day by day inspections should be carried out so as to reduce the chance of forklift accidents.



Turn off the engine before checking various fluid levels: fuel, engine oil, brake fluid, hydraulic oil and coolant. The tires must be inspected for indications of wear and tear. Check the air pressure in the tires. Check the condition of the forks. The load backrest must be firmly attached. Do a visual check of the top-clip retaining heel and pin. Next perform an inspection of the hydraulic hoses, mast chains, cables and stops. Ensure that the finger and overhead guards are securely attached.



The LP powered forklift has propane tanks that need to be inspected for rust, corrosion or damage. The battery's electrolyte levels and charge need to be tested periodically. Seat belts need to be checked for wear and tear. Check to make sure the owner's instruction manual is stored on-board the forklift inside a storage compartment. Check the seat belt to make certain the latches are secure. Check the hood latch to ensure it is functioning as it should.



To make certain there are no unusual engine sounds, start the engine up and listen for any irregularities. If there are, investigate promptly. Test the accelerator and the steering controls. The parking break and the service break should be correctly functioning.



To guarantee proper functioning in both reverse and forward, the drive control and tilt control must be inspected. The functioning of the hoist, the lowering control and attachment control needs periodic inspection. Test the horn and lights. Afterward check the heater, defroster and wipers to make certain they are working smoothly. Inspect every gauge to find out that it is reading within functional limits.

• Skytrak Zoom Boom Portland
  There are 5 units ranging in lift height, range capacity and reach capacity. Day after day you will be attaining new goals and turning corners on job performance. These kinds of machines would keep performing... More
• Pecco Cranes Portland
  Parts of a Tower Crane Tower cranes allow the construction industry to build some wonderful structures. These cranes have been utilized to reach ever-increasing heights. Tower cranes offer the means to move and raise supplies,... More
• Doosan Propane Forklifts Portland
  Propane Motor Fuel & Forklift Safety Propane-powered lift trucks are widely utilized in different industries. These forklifts are normally found in distribution centers and warehouses, in addition to in both industry and commercial applications. Propane... More
• Terex Electric Scissor Lifts Portland
  How to Charge a Scissor Lift Lots of individuals value the convenience of using a scissor lift. The convenience of working and the safety offered from the lift's basket provide much more piece of mind... More
• Yale Big Forklifts Portland
  Frame To be able to deal with the lifting stresses of standard forklift, the frame has to consider these very important factors. Yale frames offer optimal strength and rigidity for a long life. They provide... More